Vornado Whole Room Air Circulator Instruction Manual download pdf (Page 10)

10 English

WARNING: To avoid risk of ﬁre, electrical shock, or injury to persons, make

sure the Air Circulator is still unplugged before removing the blade.

It is possible to remove the blade should something

accidentally get wrapped around the motor shaft.

VFAN JR: Once the grill is removed (see GRILL

REMOVAL section) pull the blade straight out from

the shaft (Fig. 1). When replacing, the blade can

only go on the shaft one way. Push the blade all the

way on the shaft until it bottoms out. Do not use a

hammer as this could result in bearing damage.

VFAN & VFAN SR: Once the

grill is removed (see GRILL

REMOVAL section) unscrew the

Blade Cap clockwise (Fig. 2).

Then pull the blade straight out

from the shaft (Fig. 3). When re-

placing, the blade can only go

on the shaft one way. Push the

blade all the way on the shaft

until it bottoms out. Do not use

a hammer as this could result in

bearing damage. Replace the

Blade Cap.

WARNING: To avoid risk of ﬁre, electrical shock, or injury to persons, unplug

the Air Circulator before removing the grill.

To protect paint, apply masking tape over the head of a ﬂat screwdriver and

up to about 2 inches on the screwdriver shaft. Place ﬂat screwdriver against the

angled section of the grill support tab, (as shown) and press outward to allow

the grill wire to be released from the support tab. Repeat on second and third

grill support tab. To reinstall, relocate grill wire ends into the support tabs,

use the ﬂat screwdriver to ﬂex back the support tabs to allow grill to snap into

place. Be sure all three grill wire ends are engaged.

GRILL REMOVAL BLADE REMOVAL

Fig. 2 Fig. 3

Blade Cap

Fig. 1

For service questions, call Vornado at 800-234-0604

For sales inquiries, call Sylvane at 800-934-9194 or visit www.sylvane.com

1 2 ... 5 6 7 8 9 10 11 12 13

No comments

Vornado Whole Room Air Circulator Instruction Manual Page 10